Edge Angle offsets

[Moshkopp]

Got a Problem with the Edge Angle, After I measure the Edge Angle of my Object I run the First gCode. After finishing 1. Side I turn my Object and load the 2. gcode. Measure Edge Angle again and it seems that he always had the Offsets from first Measuring. I cleared Offsets measure again and it fits. But in Toolpath visulization it looks strange.

but he Runs the right way...

[Lcvette]

you need to clear the backplotter maybe? also in the offsets page the rotation offset can be seen if one is active it is under R on the far right, when you clear the offsets table you must also reload and save the table for the offsets to be zeroed if done that way.