Emfit QS Sleep Tracker Component for Home Assistant

This component provides real-time data polled directly from Emfit QS Sleep Tracker devices. Useful for automations based on bed presence and sleep detection (via heart rate bpm levels).

NOTE: This component has only been tested with Emfit QS firmware version 120.2.2.1.

Supported Features

• Bed Presence binary sensor
• Time in Bed (seconds)
• Heart Rate BPM sensor
• Respiratory Rate sensor
• Activity Level sensor

IMPORTANT: Your Emfit QS device must be accessible by Home Assistant on your local area network.

Installation

HACS Installation

This repository is part of the default HACS store. Search for the "Emfit QS Sleep Tracker" component in HACS and install it from there.

Manual Installation

Copy the custom_components/ha-emfitqs directory into your /config/custom_components directory.

Component Configuration

Add the following to your configuration.yaml file:

sensor:
  - platform: emfitqs
    host: 192.168.1.x # Replace with your Emfit QS device IP Address.
    scan_interval: 10
    resources:
      - heart_rate
      - respiratory_rate
      - activity_level
      - seconds_in_bed

binary_sensor:
  - platform: emfitqs
    host: 192.168.1.x # Replace with your Emfit QS device IP Address.
    scan_interval: 10
    monitored_conditions:
      - bed_presence

Sensor Resources & Monitored Conditions

NOTE: In Home Assistant, the component sensor names include the device serial number, for example binary_sensor.emfitqs_012345_bed_presence and sensor.emfitqs_012345_heart_rate where "012345" is the device serial numer. This allows you to add multiple entries in your config file.