Possibility to flash to a Wemos LOLIN32 board

[augisbud]

I have tried out the method to use the provided OTA updater to flash a Marauder firmware, to be specific the _flipper.bin but every single one was the same.

The flash completes at a 100% however I get a message in the Serial console:

Update: esp32_marauder_v0_9_13_20220806_flipper.bin
E (75435) boot_comm: mismatch chip ID, expected 0, found 2
Could Not Activate The Firmware

The module I am using is a Wemos LOLIN32 v.1.0.0 4MB Flash My partition scheme is Minimal SPIFFS (Large APPS with OTA)

If I were to flash the .bin file directly to the ESP32 which binary address should I use?

[justcallmekoko]

What version of the arduino-esp do you have installed?

[augisbud]

Sorry for the late reply, it's 2.0.0-rc1

[augisbud]

bump