ankermake-m5-profile
ankermake-m5-profile copied to clipboard
just-trey
Base repo for AnkerMake M5 configurations for Cura and PrusaSlicer.
the print time given in Cura is way off and takes much longer than estimated. thanks!
Due to a fix for an old homing behavior, the nozzle spits out a fat glob of filament just before a print starts. Reccomend removing the over-retraction fix in start...
Settings that will generate gcode based on an assumption of 12mm3/s volumetric speed of PETG (general average based on testing performed). Should be a solid 'no fuss' PETG printing profile,...
These are the general filament cooling and retraction settings I've found to be most helpful when printing with PETG. These prevent blobs on travel and massively reduce stringing.
First of all thank you for the awesome profile for the M5! I have a question / an issue regarding the default printing temperature. When I use different materials from...
I set a print in Cura to have a speed setting of 50mm/s but when it got imported into AnkerMake it had a speed of well over 300mm/s The speed...
Love this profile! Slicing with this produces *much* nicer results than using AnkerMake's slicer. Any chance someone could contribute a Generic FLEX or Generic TPU filament profile? I tried copying...
Reduces the top print speed for the .2 and .3 profiles Removes the .4 and .45 profiles (the speed needed to be slowed down to the point where the print...
I've updatd the extruder dimensions and gantry height for both Prusa and Cura slicer to have better support for sequential printing. Along the way I ran into various quirks with...
