fbcp-ili9341
fbcp-ili9341 copied to clipboard
juj
SEPS525 supported?
Hello,
Is it possible to add support for SEPS525 display? I'm using this display in a VMU mod with Pi Zero, but the refresh rate is killing the experience...
Datasheet: http://www.newhavendisplay.com/app_notes/SEPS525.pdf
The mod: https://sudomod.com/forum/viewtopic.php?t=6917
I hope something could be done about this...
The display does look like it could be supported within current driver design. I don't unfortunately have the display (or even if I did, unfortunately not able to spend time to work on adding support at the moment).
If someone has the display and is able to find a spec sheet or reverse engineer the bus, pull requests would be welcome!
As far as I read the bus is very well described in the attached datasheet? Unfortunately my programming skills are not enough to pull this off, that's why I asked here... Since the bus i documented I could try, but I would need some guidelines how to start.
Oh right - indeed, the spec sheet documents the protocol. In general the porting process is as follows:
- Write the initialization sequence for the display. E.g. ILI9341 has it here
- Write the pixel cursor update sequence protocol, e.g. for ILI9341 here.
- Write any needed display-specific color conversion e.g. here
- Address any other display-specific aspects that the display is incompatible with against the existing driver (e.g. partial window sets, DMA, or something else)