Initial Commit of ABSIS Pro-Micro

[kbastronomics]

Contains the Open Hornet Version of the Pro-Micro 1.3 PCB. 5 were ordered from JLCPCB and validated as working as expected.

Description

This is the initial pull request for the ABSIS Pro-Micro PCB.

Addresses # 1114

Motivation and Context

The available Pro-Micro's have a random issue on some board where the RAW power if used will cause the on-board regulator and associated capacitor to blow. This resolves that issue

Type of change

New PCB Design

Please delete options that are not relevant.

• [X] ECAD - New PCB (A new PCB!)

How Has This Been Tested?

Multiple Iterations of the PCB ordered and tested thru JLCPCB Burned Bootloader, Flashed with OH Code and validated,
Applied up to 15v on RAW pin with no signed of failure.

Screenshots:

did not exist prior

Checklist: (Delete non-relevant sections)

PCB/ECAD:

• [X] Requirements definition completed as a note on the schematic?
• [X] Schematic completed?
• [X] PCB laid out?
• [X] PCB routed?
• [X] PCB constrained by physical footprint limitations?
• [X] PCB critical component location requirements met?
• [X] Version number updated on PCB silkscreen, and the PCB and schematic docs?
• [X] Schematic/PCB reviewed?
• [X] BOM generated?
• [X] Gerbers generated?
• [X] MCAD generated?
• [ ] Has the fabrication files and a PDF of the schematic been copied to the ECAD folder of the release folder?

[jrsteensen]

Also, are there basic (for the cap) or high stock number parts that can be substituted in the design for these parts?

[kbastronomics]

Title block updated on Schematic and PCB attributions moved update 22pf cap Green LED was out of stock at time you looked Added a note for a possible alternative for the USB connector (untested) working on markdown for firmware instructions will submit PR again when firmware instructions are ready