OpenHornet
OpenHornet copied to clipboard
jrsteensen
[Bug]: 3D models for switch TL1240GQ on the DDI pcb are in the wrong orientation in KiCad
Discord Username
1_neox_1
Bug Summary
The 3D models for the switch TL1240GQ inside KiCad for the DDI pcb are in the wrong direction and are misleading.
Expected Results
The 3D models for the switch TL1240GQ inside KiCad for the DDI pcb should follow the manufacturer datasheet. (https://www.mouser.ca/datasheet/2/140/TL1240GQ-3458821.pdf https://eswitch.wpengine.com/wp-content/uploads/2022/06/TL1240.pdf)
Actual Results
The long lead (anode according to the manufacturer datasheet) on the 3D model is not on the positive source and is on the cathode position / GND.
Screenshots/Images/Files
Applicable Part Numbers
OH1A3-1
Release Version
v0.2.0
Category
Electrical (PCBs/Wiring/etc)
Applicable End Item(s)
Upper Instrument Panel (UIP)
Built to print?
- [ ] I built (or attempted to build) the part to the OpenHornet print without any deviations.
- [ ] I am not building this part to the OH print. (List deviations in detail in the Miscellaneous Info text area below.)
Miscellaneous Info
No response
Verified the 3D model is rotated 180 degree's from where it should be. i already have the PCB file updated and will submit a pull request for it.
@kbastronomics If you could go ahead and make the changes to MCAD by integrating the new PCB in the model. If any drawings are Rev - that are impacted, please rev them to Rev A as well, then submit the updated ECAD & release package drawings. No Master BOM updates should be required.
