john30
Hc1RoomTempMod missing in new configuration
I finally migrated from version 23 to 25. In the old configuration i had the topic mode_state_topic: "ebusd/ctlv2/Hc1RoomTempMod" used for my thermostat.
What is the new topic for this?
Old: r;w,,Hc1RoomTempMod,,,,,1500,,,rcmode2,,,room temperature modulation of Hc1 r;w,,z1HeatingRoomTempDesiredManualControlled,Desired Heating Room Temperature Zone 1 manual controlled,,,,2200,,,tempv,,,manual controlled desired heating room temperature for zone 1
I found al corresponding mappings in the "new" CSV file. only one that is missing is Z1roomhumidity. Is there an easy way to add this value in a easy way local to the CSV file?
r, z1RoomHumidity, B524, 020003002800, EXP, %
Tried to add a row. but as soon i reload the CVS it gives me an error.
What error do you get?
Have you tried
r,ctlv2,z1RoomHumidity,z1RoomHumidity,31,15,B524,020003002800,value,,IGN:4,,,,value,,EXP,,%,z1 Room Humidity
This works for me albeit earlier release.
You may find it helpful to set the --enabledefine parameter at startup so that you can load a single config line while you debug. (If you do this the loaded definition cannot rely on defaults of course which is why it is fully expanded in the example above.)
(presumably your spaces after commas and number of comma separators are not intended?)
