betaflight
betaflight copied to clipboard
joelucid
Hello, when using CRAZYBEEF3RX 4.1 target from here on Happymodel Snapper6 with Frsky R-XSR soldered to TX pad with fport, FPORT configured, Serial enabled, RX bound, the receiver tab in...
I am curious if there is coming a new update? And whether the new bfp f3 also has rpm filter support, for the ff_piko_blx?
Hi, I'm new here so forgive me if this has already been stated and this is the wrong thread. I just flashed my SP Racing Pro F3 v1 board with...
Hi. I'm using LittleBee ESCs with 16.73 firmware. Motor beeps last OK (high-tone)beeps before 4.1.1-EA3 And I flashed FC to 4.1.1-EA3. After that not beeps OK sign. Only beeps initial...
Build also all targets with frsky fport support thanks for this great branch :+1: keeps my F3 alive (:
Just wanted to ask, if you could provide an "USB broken - rescue" image? I'm currently using my omnibus F3 board with broken USB port and UART1 is the default...
CRAZYBEEF3FR 4.1.1 EA3 has problems with current and voltage when voltage is above 4.0V. It shows 0 amps, 0 mah and voltage is shown as more than 4.3. When voltage...
Hardware Info: - Copter: Leader 120 - FC: F3 OMNIBUS Board Software Info: - runs fine with official 3.4.x as well as self-compiled BF4.1 and BF4.2-RC2 Issue with Performance Edition:...
These were remains of early development.
