jks-prv

You can configure a single-range, positive-offset down conversion parameter on the config tab of the admin page. See the "frequency scale offset" field.

I think I've seen this too. Especially when using shift-alt/option-click to toggle the type between active and watch-list. The underlying method used to send the update message from client to...

It has been suggest that because rx channels are such a precious resource there should be a property "matrix" that allow independent settings for each channel. Things like if a...

Christoph has been looking into that (when he has time available): https://hcab14.blogspot.com/2019/02/chirp-sounder-measurements-with-kiwisdrs.html I don't know much about it myself.

If you're a Kiwi owner/admin the system stats info is available on the status tab of the admin page. I don't disagree with any of this really. I've been holding...

I was going to write an extension that worked the same as Twente WebSDR's "S-meter plot" display. A nice signal strength "strip chart" with variable speed, time stamps and auto-scaling.

Sure, all good ideas, and all possible.

Hi. That same update added separate S-meter and waterfall cal adjustments to the admin > config panel. I'm still getting the bugs out. The S-meter cal takes effect immediately, even...

I'm not sure I want to do this (yet). With this change Firefox will complain that sending a password is not secure because https is not being used. This is...

Yes, I agree. Please email me directly at [email protected] to discuss. And please excuse my lack of knowledge about security best practices. I am learning about a lot of these...