jheling

Hello, When I started with this integration there had to be a link from the sensor to the actuator if you wanted to see a button press of the sensor...

One of the requirements is : A system access point 2.0 with at least version 2.6.0 must be available. Do you have this 2.0 version? My system is five years...

Hello, when developing this integration i choose to use the ip address as a unique identification for home assistant. Looking back, i should have chosen the mac adress or something...

It uses the zeroconf integration to discover free@home. The documentation says the following: Zeroconf chooses which interfaces to broadcast on based on the [Network](https://www.home-assistant.io/integrations/network/) integration. IPv6 will automatically be enabled...

Hello, that should be possible. Can you make a dump of your free@home configuration as described in section 1 of debugging?

Hello, i was expecting something else. In the readme for this integration is also a debug section. Here is described how to make a dump of the free@ home configuration....

yes, this is ok, now i have to find some time

Could you try if #178 works for you?

ok, do you see any new binary smoke detectors / co detectors in your home assistant?

Are there any errors in the home assistant log?