flatbox
flatbox copied to clipboard
jfedor2
Low profile hitbox-layout fightstick
What button is it to hold down to enter the web configurator on this pin out ? Also have built 2 separate boards now and it doesnt seem like I...
i was making a custom case for the flatbox and noticed after i had printed the first prototype that I failed to factor in the reset and boot switches, i...
The Kicad zip file cannot be processed by easyeda, just wondering if it is an issue for this particular software only
I want to install 2040zero on the PCB in reverse, with the type-c interface facing downwards, which can save some space and make it thinner. But I can't write firmware,...
I had issues with the buttons on the flatbox being wobbly, so I pulled the STL's into blender and made some small changes - Stems shortened by 0.5 mm -...
Hello, First off, thanks for creating this project, I'm sure it'll work amazing, right after I have it fully set up. I'm having some difficulty with the soldering potion. I...
When uploading cpl file on JLCPCb error message below is generating. any solutions? 
Is the rev1.1 pcb designed such that I can flip the layout and solder the switches and buttons on the other side?
Is the 3D printed case the same for Rev4 and Rev5? I printed a Rev5 case, but now want to buy a Rev4 PCB. Thanks!
