dactyl-keyboard
dactyl-keyboard copied to clipboard
jaredjennings
Parameterized ergonomic keyboard
The thumb is hard-coded. I don't think it can be shoehorned into maps and lists like the description of other parts of the keyboard found in the layouts variable in...
The bottom of the keyboard has somewhere from 3 to 15 pieces (depending on how big I tell them to be). Other than all of them being just the right...
The objects used to split the bottom of the keyboard are regular hexagons. I don't want a leg joint or screw hole base to be split into two pieces by...
I'm watching four ```openscad --render```s trundling away and pondering about how all four are thinking about what the bottom of my keyboard is shaped like. It's a big waste of...
Get a Pi Zero W and a battery. Stuff them inside the keyboard. Run connectors (e.g. charging, video) to the edge of the keyboard. Figure out how to put some...
After a keyboard exists, think about how it could be used on a bus, or in other situations where I have a lap but not a desk.
Gather and photograph the plastic, and render the shapes, that preceded this point.
The sides printed at 3mm thickness (well, the one piece I have) are satisfyingly solid but take forever to print. So I reduced the sides-thickness to 2mm. But then I...
I've printed a piece of the frame with the switch holes without nubs (see adereth#56). My Kailh Brown switches fit, but not tightly enough. Tweak the hole to be a...
It could be because they are pentagonal, or because I've confused their radius and diameter. But drilling one of them out didn't work well.