3D Printable Quefrency Case

For the Quefrency - 60%/65% Split Staggered Keyboard

Notes

• The 60% layout has not been tested yet! I only own the macro + 65 percent versions of the PCBs. Please double check the dimensions before using. The screw holes should be the same in all versions.
• The photos show the split "wall" rising up into the top part of the case. This was removed as it tends to rattle.
• Designed to use M3 bolts and brass heat set inserts.

Parts

• M3 x 5mm(L) x 5mm(OD) Brass Inserts
• M3 Bolts
• Bumpons any size is likely fine
• 3mm x 8mm Magnets