James Morris

Do the measurement values still change when you add or subtract weight? As in the measurements are still working properly but drifting slowly? The way I use HX711 measurements is...

I don't work with this repo anymore as I needed much more parallel sampling functionality. If you have time and want to switch to a different module, mine is over...

@Raxo96 I don't think there has been a code update since this issue. I had trouble adapting this code to multiple HX711 sensors, so I made my own repo with...

Your red chip doesn't have a label on it, but based on the circuit board it looks like the orientation of the HX711 is the same as in the picture...

@Klaudia19 the tare can fail if the measurements coming in are bad, or have a lot of noise. Usually a failed tare/zero is because of bad wiring. You can check...

I'm having this same issue after setting up a new MacBook. It seems like some operations work, but after I try to do an `amplify push`, that fails and then...

The error you're getting indicates that the "hx" object just doesn't recognize a "zero()" function. Are you sure you have the correct hx711 module installed and imported? I don't maintain...

@snakepatricia I doubt that this specific error means there's something wrong with the Pi other than the installs. Have you tried uninstalling hx711 and reinstalling with that pip command? pip3...

This isn't my repo, but you should first check all your wiring matches the GPIO pins you have set. You should have the clock/sck pin and GPIO input pin wired...

Here's a wiring diagram I have of the HX711s I use.