issalig
issalig
Any progress?
Check debug CMD and it will show the decoded messages. From there you can set status, speed, etc... from your remote and sniff the communication. 
if you are able to switch it on/off that means hw is ok because communication works. It is strange that you do not receive anything. If you check the Debug...
I tested the module with my air conditioning and it worked both RX/TX. I do not know if there is sth different in yours. What about if you disconnect RBC-AMSU51-ES?...
Ooops, I do not really understand what is happenning. Do you have an oscilloscope/logic analyzer?
I have used one like this to sniff the protocol. aliexpress.com/item/1005007112122595.html Warning! If connected directly to AB cable you should put a resistor divider to go from 15V to 5V...
First, I would use it on the board on pins D7 (Read) and D8 (Write). Just unplug wemos, connect logic analyzer probes to D7, D8 and GND. The board provides...
Great news! Hahaha, I have also been busy integrating it with HA. Not still finished but almost. Also I have been working on the web interface. I use Pulseview under...
No, GND should be connected to GND pin in logic analyzer. I am planning to upload my new depelopment to a new branch once it is more or less stable....
Hehe, I see, yours have CND -> Chinese gND, so connect it to CND