dahua icon indicating copy to clipboard operation
dahua copied to clipboard

Published 20 hours ago • verified publisher icon rroller

Tested cameras

Open NLOscar opened this issue 1 year ago • 1 comments

Hi, These are working.

DHI-VTO2111D-P-S2 by Dahua Firmware: 4.500.0000000.5.R,build:2020-10-26

VTO2111D by Dahua Firmware: 4.300.0000003.0.R,build:2020-03-11

NLOscar avatar Mar 21 '24 12:03 NLOscar

(Please, note that the menu and setting names reported below may differ from the original English ones, since they were back-translated in English)

Other working (with caveats) cameras/firmware:

DH-IPC-PFW3849S-A180-AS-PV by Dahua Firmware: 3.140.0000000.10.R,build:2024-01-16 DH-IPC-HDW3549H-AS-PV by Dahua Firmware: 3.140.0000000.13.R,build:2024-01-24 $

$ = requires changes in camera settings:

  1. log in the camera using its Web interface;
  2. follow the path: Network Settings->Basic Services
  3. set "Authentication" to "Compatibility Mode". If the default "Safety Mode" is used, the camera is (apparently successfully) installed in HA as "Generic RTSP" with "Firmware: 1.0". However, with this setting, nothing works properly and any further command/setting will fail with different kinds of "access denial" messages.

Warning: since I have just installed the cameras on a fresh Home Assistant install, and because of my inexperience in HA, only few features and interactions have been tested. However, previews, motion detection and illuminator's switching on/off are working flawlessly.

pamodeo-icb avatar Mar 25 '24 21:03 pamodeo-icb