nfoppiani-pf

Results 5 comments of nfoppiani-pf

Generate a closed solid from a 2d spline doing Face -> Shell -> Solid

Understood. However, the shell turns out out to be correct if exported to .step or .stl. Would it be possible to find a workaround for me to generate a solid...

Generate a closed solid from a 2d spline doing Face -> Shell -> Solid

My use case is to generate closed toroidal-like geometries by creating 2d splines through the points. I don't fully understand why the area is zero. If you export the shell...

Create a closed loop with rectangular cross section - obtaining two extra unwanted faces

Thank you for your answer. Unfortunately, even with >= 109 points I still see the same problem when opening in FreeCAD. How did you perform your check on the number...

Create a closed loop with rectangular cross section - obtaining two extra unwanted faces

Thank you! I think I tried something like this hack before but it did not solve the issue in my case. I will try to see if perhaps there is...

Create a closed loop with rectangular cross section - obtaining two extra unwanted faces

Thank you so much, that's really helpful! Is there a way to remove seam edges?