DWM1001-Real-Time-Localization-System icon indicating copy to clipboard operation
DWM1001-Real-Time-Localization-System copied to clipboard

Published 20 hours ago • verified publisher icon jonathanrjpereira

How to set Initiator?

Open twshen2000 opened this issue 2 years ago • 0 comments

No change after set the configure in swm-simple.c set_a_cfg.initiator = 1;

dwm> FW Major: 1 FW Minor: 3 FW Patch: 0 FW Res: 0 FW Var: 1 HW Version: deca002a CFG Version: 00010700 RV: -5 Anchor Get mode 0 Anchor Get initiator 0 Anchor Get bridge 0 Anchor Get motion detection enabled 0 Anchor Get measurement mode 0 Anchor Get low power enabled 0 Anchor Get internal location engine enabled 1 Anchor Get encryption enabled 0 Anchor Get LED enabled 1 Anchor Get BLE enabled 1 Anchor Get firmware update enabled 0 Anchor Get UWB mode 2 PAN ID: 1 Set Position Quality Factor: 100 Set Position coordinates X: 5000 Set Position coordinates Y: 7400 Set Position coordinates Z: 1300 Get Anchor Position [0, 0, 0] Configurations Completed

twshen2000 avatar Sep 25 '23 02:09 twshen2000

I have the same issue, any chance that you were able to figure it out and still remember how you did it?

Mtuey17 avatar May 09 '24 19:05 Mtuey17