jm20122012

> UPDATE: > > I spoke too soon, the touchpad eventually dies even using the synaptics drivers. It does last longer but the touchpad experience is much worse with synaptics....

@starbasessd @Dewey3 I will try to test this afternoon when I get off work. It seems like the recommended workaround should work though, but I'll confirm this afternoon. This might...

@Dewey3 Also, if you have the ability during boot to temporarily connect the Pi via ethernet then you can just use the eth0 IP address to configure the WPA details...

Thank you @starbasessd . These instructions really should be added to the install instructions. The install instructions currently state: "Of course your motionEyeOS needs an IP address before you can...

https://github.com/ccrisan/motioneyeos/wiki/Installation

No problem, thanks for looking into this.

@carlkidcrypto Hello. I apologize for not getting back sooner. After not being able to fix the issue after a few days I ended up moving on to another solution and...

@sjmccorm1993 So I'm not 100% sure what exactly is being done here to handle for the keyError. Are you suggesting using pd.Series() to initially hold the values, and then assign...

It actually looks like "0.0.0" was hard-coded [here](https://github.com/nats-io/nats-top/blob/a622dfe09b3a1a2e7381121ff33aa0e732d2055c/nats-top.go#L39). Was this intentional?

Yes, still broken unfortunately. I've just been using the Dreo app in the mean time.