FabGL

FabGL copied to clipboard

Hi, I did compile the Multitasking-CP/M for a TTGO VGA32. After the first compile WIFISCAN did told me to activate HAS_WIFI in /src/defs.h but here it was already activated with #define HAS_WIFI

So I checked the source and found in /src/HAL.h

#ifndef _ESP32_SOC_H_
  #undef HAS_WIFI
#endif

which I then commented out. It seems that the TTGO VGA32 isnt recongnized as a ESP32_SOC_H :( (configured a ESP32 Dev Module in the Arduino-IDE)

After the next compile, when I do get the prompt I have serveral "^@^@^@^@^@^@^@^@^@" after the A> prompt

WIFISCAN does work :)

When I try to connect to WiFi with WIFI SSID PWD it fails (WiFi has WPA and WPA2-PSK and also a DCHP Server) Connecting WiFi...failed!

Anything else that I could try to connect/check WiFi? (PSRAM is enabled at compile-time like said in Issue 248)

PS: I have enabled SDCard Support on the TTGO VGA32 with the follwoing lines: (are they correct (it does work) or is there a better way?)

// SPI "2,12,14,13" for TTGO_VGA32 / PICO-D4 (MISO, MOSI, CLK, CS)
// allocationUnitSize 16*1024 = 16384
static int allocationUnitSize = 16*1024;
static int MISO  =  2;
static int MOSI  = 12;
static int CLK   = 14;
static int CS    = 13;

 
  if (FileBrowser::mountSDCard(FORMAT_ON_FAIL, SDCARD_MOUNT_PATH, MAXFILES, allocationUnitSize, MISO, MOSI, CLK, CS))
    basepath = SDCARD_MOUNT_PATH;
  else if (FileBrowser::mountSPIFFS(FORMAT_ON_FAIL, SPIFFS_MOUNT_PATH, MAXFILES))
    basepath = SPIFFS_MOUNT_PATH;

In my case wifiscan does not work in MultitaskingCPM, even if I comment the line with #undef HAS_WIFI, but it answers: Scanning...-2 network(s) found It answered like this even before I commented the line with #undef HAS_WIFI (I have remembered to save changes), i.e. _ESP32_SOC_H_ is defined in my case. If I try to connect to a known WiFi router it answers: Connecting WiFi...failed! Scanning for WiFi and connecting to this router and others works in NetworkTerminal for me even to WPA2.

I Serial Monitor it outputs the following when i do WIFISCAN: 17:35:38.614 -> E (643728) wifi:create wifi task: failed to create task

I use TTGO VGA32_V1.4 21-2-20 and Arduino 1.8.19 installed from Microsoft Store. PSRAM is enabled for this sketch only, but all other settings are the normal for FabGL-sketches. The BAS-demos that don't use ADC or GPIO work, e.g. GRAPH.BAS and SPRITE.BAS work. They didn't work before I enabled PSRAM, but this had no effect on wifiscan.