ESPloitV2 icon indicating copy to clipboard operation
ESPloitV2 copied to clipboard
verified publisher icon exploitagency

failed to request a device descriptor

Open kabanpunk opened this issue 7 years ago • 2 comments

After I followed these steps

Load the esp8266Programmer sketch from the flashing folder. Select Tools - Board - "LilyPad Arduino USB". Select the Port your device is connected to under Tools - Port. Upload the sketch.

from your instructions, my ESP stopped responding, and I'm getting now just that "failed to request a device descriptor". Windows does not see the device

kabanpunk avatar Aug 09 '18 14:08 kabanpunk

I have experienced this several times, the actions I have done are as follows

  1. Make sure the Driver is installed if you use Windows and the WHID has been detected, please see Device Manager => Port
  2. Reset the WHID with a small Magnet, I get it from my friend's workshop.
  • plug WHID to your computer
  • hold the magnet and close the magnet to your WHID then shake right or left quickly
  • Automatically reset the WHID to ZERO
  • do Flash from the beginning

I hope you understand my information, sorry my English is very bad.

ChandraOrbit avatar Oct 07 '18 02:10 ChandraOrbit

I'm having the exact same problem with my Cactus WHID, it's not being recognized by any device. Already tried with three different magnets and nothing seems to happen, what am i doing wrong?

demian123 avatar Apr 18 '19 16:04 demian123