modular-psu
modular-psu copied to clipboard
eez-open
EEZ Bench Box 3 (BB3) Modular T&M chassis
In the current implementation of the DCP405 Rprog setting is done relative to the internal GND of the DCP405. This makes it impossible to connect a AWG with GND to...
The Dout2 output will go high for a short time (600 to 1300 ms) after the power up. This does not happen during a software-generated restart. Further investigation is needed...
Is there a way, using the existing hardware, to allow for external current programming using the same input as would normally be used for external voltage programming? This would be...
I have seen selected MCU is an STM32F769IGT (LQFP176) which is very good anyway I think for future and to manage even more things it will be a must have...
I would like to have the possibility to have parallel operation of modules in slot 2 and slot 3. This creates more flexibility to combine (future) modules like electronic load....
Currently the fan of the BB3 pushes the air from the back to the front/top/side air vents. If modules produce heat (for example an electronic load) and have vents on...
Warning: this is not straightforward action since existing USB is OTG and we're using ID signal that does not exists on USB-C. Therefore we should use extra device for translating...
Added RS485 port for easier integration with T&M automation and industrial environment. If isolation is desired, a DC-DC isolation converter can be added which can also be used to power...
Perhaps the digital I/Os should be isolated. In that case, the question remains how to power the other side of the digital isolator.