BIGTREETECH

May I ask which interface did you stop at in the final printing process and then crash?

> Hello, I used the BTT graphical interface with babystepping.Z-Offset was default (0). I started a print and adjusted the Z-Offset with babystepping. Stored it to EEPROM. Then I canceled...

> I left it on to view the Camera as my printer is in a closed cabinet OK, I have determined the cause of the problem, and I will issue...

> I left it on to view the Camera as my printer is in a closed cabinet Hello, you can update your OCTOBTT by following the command below; The usage...

Thank you for your feedback: This is certainly a problem that has a big impact on usage, but I haven't found it yet. As for your feedback, I will test...

> yea have same problem now, i first installed icons was a nice size now there a bit wee for me to see unless am really close Is it convenient...

> [Image][Image] > […](#) > ________________________________ From: BigTreeTech Sent: Monday, 26 October 2020, 12:23 To: bigtreetech/OctoBTT Cc: skinz98; Comment Subject: Re: [bigtreetech/OctoBTT] Icons and font have been downscaled? (#19) yea...

As for the icon problem, we cannot perfectly fit it in the current architecture scheme. We have adapted this problem in the new UI, but it still needs time to...

In order to ensure the stability and anti-interference ability of the communication connection, it is recommended to use the intermediate 115200 Baud rate value. The default setting of the program...

Hello, you can modify the baud rate of the printer to 115200 so that OctoBTT can automatically connect to the printer.