ant0nyk1ng
ant0nyk1ng
> create automount rules in your armbian environment, this way you should be able to use the host-sdcard-slot G4Cab ... where can I find a step by step instructions to...
> I hired some one on fiver to rewrite the code to trigger with a switch, but nothing happens idk what's wrong. Sent from Yahoo Mail on Android On Tue,...
> I had the PCB made and used all the components, unfortunately after measuring I found out that the PCB is badly made and I threw it away! I made...
Ok I revisited the latest Bugfix and the same issues prevails. Here are the config files and also I have added the ouput from Pronterface with G28 and G29 [Configuration.zip](https://github.com/user-attachments/files/15544138/Configuration.zip)...
> MicroProbe requires a pin with a pull up on the trigger signal, its not as board agnostic as other probes. > > This is why we have the warning...
Lol it wont Bed level now? Connecting... Printer is now online. >>> g28 SENDING:G28 echo:busy: processing echo:busy: processing echo:busy: processing echo:busy: processing echo:busy: processing echo:busy: processing echo:busy: processing >>> g29...
Ok checked over the latest bugfix firmware and ran some reports with M111 S247 G28 [G28_Pronterface_output.zip](https://github.com/user-attachments/files/15597413/G28_Pronterface_output.zip) G29 [G29_Pronsole_output.zip](https://github.com/user-attachments/files/15597418/G29_Pronsole_output.zip) Config files [Configuration.zip](https://github.com/user-attachments/files/15597426/Configuration.zip) So as per the conversations above running G33 runs...
I was using Bilinear Bed Leveling so I turned on UBL and Building a Cold Mesh resulted in a fail so I took a video and you can see it...
> try adding one of those ferrite cores around the wires. maybe its EMI interference. > > because this probe is really small, maybe whats happening is the probe isnt...
Ok after failing with AUTO_BED_LEVELING_LINEAR, AUTO_BED_LEVELING_BILINEAR, and AUTO_BED_LEVELING_UBL never finishing without starting to probe in the air and failing. So I tried AUTO_BED_LEVELING_3POINT and it seems to run and finish...