logiops icon indicating copy to clipboard operation
logiops copied to clipboard

Published 20 hours ago • verified publisher icon PixlOne

logid fails to start with device timeout. times out immediately. works randomly

Open rayzorben opened this issue 2 years ago • 2 comments

When logid runs it will hang at timed out, waiting for input from device to initialize.. It never proceeds. I re-run it 2-5 times and it starts working. This is an issue because running in a service I never know when it is going to work other than to just keep restarting it.

Here is where it doesn't work (note that the timed out prints IMMEDIATELY.

sudo logid -v
[WARN] Error at line 17: SettingTypeException
[WARN] Error at line 22: SettingTypeException
[DEBUG] Unsupported device /dev/hidraw7 ignored
[DEBUG] Ignoring virtual node on /dev/hidraw2
[INFO] Detected receiver at /dev/hidraw1
[DEBUG] Unsupported device /dev/hidraw4 ignored
[DEBUG] Unsupported device /dev/hidraw5 ignored
[DEBUG] Unsupported device /dev/hidraw6 ignored
[DEBUG] Unsupported device /dev/hidraw0 ignored
[DEBUG] /dev/hidraw1:1 timed out, waiting for input from device to initialize.

Here is where it works:

sudo logid -v
WARN] Error at line 17: SettingTypeException
[WARN] Error at line 22: SettingTypeException
[DEBUG] Unsupported device /dev/hidraw7 ignored
[DEBUG] Ignoring virtual node on /dev/hidraw2
[INFO] Detected receiver at /dev/hidraw1
[DEBUG] Unsupported device /dev/hidraw4 ignored
[DEBUG] Unsupported device /dev/hidraw5 ignored
[DEBUG] Unsupported device /dev/hidraw6 ignored
[DEBUG] Unsupported device /dev/hidraw0 ignored
[DEBUG] /dev/hidraw1:1 timed out, waiting for input from device to initialize.
[WARN] Error at line 17: SettingTypeException
[WARN] Error at line 22: SettingTypeException
[DEBUG] Unsupported device /dev/hidraw7 ignored
[DEBUG] Ignoring virtual node on /dev/hidraw2
[INFO] Detected receiver at /dev/hidraw1
[DEBUG] Unsupported device /dev/hidraw4 ignored
[DEBUG] Unsupported device /dev/hidraw5 ignored
[DEBUG] Unsupported device /dev/hidraw6 ignored
[DEBUG] Unsupported device /dev/hidraw0 ignored
[INFO] Device found: MX Anywhere 3 on /dev/hidraw1:1
[DEBUG] /dev/hidraw1:1 remappable buttons:
[DEBUG] CID  | reprog? | fn key? | mouse key? | gesture support?
[DEBUG] 0x50 |         |         | YES        | 
[DEBUG] 0x51 |         |         | YES        | 
[DEBUG] 0x52 | YES     |         | YES        | YES
[DEBUG] 0x53 | YES     |         | YES        | YES
[DEBUG] 0x56 | YES     |         | YES        | YES
[DEBUG] 0xc4 | YES     |         | YES        | YES
[DEBUG] 0xd7 | YES     |         |            | YES

rayzorben avatar May 26 '23 00:05 rayzorben

I have the same issue with a M650. Additionally, unplugging and replugging the bolt dongle or turning the mouse on and off while logid is running fixes it.

markozajc avatar Aug 29 '23 20:08 markozajc

Same here with an MX Master 3. Can confirm the workaround from @markozajc works for me as well.

isalgueiro avatar Oct 25 '23 10:10 isalgueiro