ilyaq

Hi, chimeno I think you're right. I'm using the LinuxCNC distribute 2.7.12. Can you tell me where to find knowledge about RP-PREEMPT? `uname -a` `Linux debian 3.4-9-rtai-686-pae #1 SMP PREEMPT...

Hi, chimeno I used the second option and installed linuxcnc which you advised me. It helped, thank you! But now I get another error. I am trying to run swm-fm45a...

Hi, chimeno First, Thank you for your help May I clarify? What configuration do you mean? I can't use `loadrt lcec` in my hal file. I get the error Do...

Hi Chimeno, i have two servo drive Delta ASDA A2-E. If I don't edit .xml file, then the program will not start? I mean. I used `loadusr -W lcec_conf ethercat-conf.xml`...

Hi chimeno, You've already helped me a lot. And I'm ashamed of myself, but I still need help. I've been trying to figure it out on my own, but so...

Hello Chimeno, Yes, It worked! Many thanks! Following your example, i found in file lcec_deasda.c this parameter - pos-scale and used it instead of srv-pos-scale. Now I get the following...

Hello chimeno, Thank you for your time and help It works, but it's wrong. This is a speed feedback, not a position. and when the engine stops, the data on...

Hello chimeno I found the right pin. If anyone needs it, then you need to use the following `net x-post-fb