ilium007

I set up the test circuit on a breadboard. First I tried with the 10k / 0.01uF RC circuit and no Schmitt Trigger IC: ``` >>> MPY: sync filesystems MPY:...

Just for giggles... Using the exact same hardware and the Mike Teachman library I got this result: ``` MicroPython v1.18 on 2022-01-17; Adafruit Feather STM32F405 with STM32F405RG Type "help()" for...

Unfortunately I don't have a proper scope so can't reliably create the waveforms you need. I'm using the Teachman library for now as I can't get it to fault at...

*facepalm* yes... that worked.

lol - I was sitting here in front of the sensor trying to figure it out ! One jumper wire and it worked !

Is this fixed in v1.1.1 on OSX? I just downloaded and got the max_extrude_cross_section error on first print. *oops - I am using arcwelderlib not this code. Obviously the issue...

I also have a spare v2.4 board that I haven’t touched as yet. 

It turns out my spare board was a DPS5020  But it’s output measured on the same meter is spot on. I’m not confident now putting OpenDPS on the DPS5020...

Is there a guide for this process?

I’ve just had a look through the commits referenced above and it looks like I understand enough to calibrate. How far apart do the voltage references have to be? Would...