iVirtualPlays

> yes, all three pins need to be lifted Only Pin 12 needs to be lifted or it's trace cut, since Pin 1 and 44 don't go anywhere.

My first attempt and no luck at the moment, it just gives me a black screen. This unit has had failed Dragoncity PCB and Piggy Back Bios mods, hence the...

Done it on the other unit, but I can only boot into one of the BIOS's. Did I hook it up the toggle switch wrong?     ...

I tried switching the wires around on the switch aswell as reflowing my install, but that doesn't fix the issue. It looks like the Pin 12 bank doesn't boot. But...

 Can't reflash the bios.

Apologies for the confusion with the title. I wish I can edit that out. I was lead here by a Triple Bypass mod post, but I just wanted that one...

>  Thanks for the reply, much appreciated. Does that mean Pin 12 still stays cut? And Pin 44 gets wired to the nearest GND point like to Pin 32?...

> remove brown wire > disconnect green wire from pin12 and connect green wire to ground > remove resistor from pin12 > solder pin12 to mainboard Thanks so it looks...

And one last question for when it starts working, can I reflash these bios's again? Can Dreamshell reflash a bios chip like this on two separate banks?