Speedybee F7 V3 servo fix

[0freechat001-sys]

Hello INAV Support Team,

I am writing to report an issue with servo outputs in INAV firmware version 8.0.1.

After updating, my flight controller does not show all my servo outputs. Only one servo works. This was not an issue in older firmware versions. When i want to 3 Servo outputs.

Could you please provide guidance on how to resolve this? I have already checked the "Outputs" tab and mixer settings.

I use Speedybee F7 V3 FC

Please help me! 

[sensei-hacker]

Please show exactly which target you flashed and a picture of exactly which flight controller you have.

Also, please show the first couple lines of the diff you saved BEFORE upgrading.

[0freechat001-sys]

I have been using and configuring the SpeedyBee F7 V3 flight controller through the SpeedyBee app via Wi-Fi, so I do not have a diff save file. everything was fine, until I updated my flight controller to iNav 8.0.1.

Please help me.

[sensei-hacker]

So did you flash with full chip erase and set up everything again from scratch?

[0freechat001-sys]

Yes, I do this every time I flash my target firmware.