new target DAKEFPVH743

[sensei-hacker]

[sensei-hacker]

• [x] Samples received
• [x] Flash firmware
• [x] Calibrate
• [x] Orientation matches
• [x] Gyro working
• [x] Accel working
• [x] Baro working
• [x] Voltage correct
• [x] Current correct
• [x] Analog RSSI
• [x] Mag I2C Bus
• [x] UART1
• [x] UART2
• [x] UART3 rx only
• [x] UART4 tx only
• [x] UART5
• [x] UART6
• [x] UART7
• [x] UART8
• [x] LEDs working
• [x] Buzzer working
• [x] Motor outputs No DMA / Dshot on M8. Would a DMAR change help?
• [x] DShot support on m1-4
• [x] Servo outputs
• [x] Blackbox
• [x] Analog Camera working
• [x] Video Out working
• [x] OSD working
• [x] PINIO1
• [x] PINIO2

[Foosh007]

• [x] Samples received
• [x] Flash firmware
• [x] Calibrate
• [x] Orientation matches
• [x] Gyro working
• [x] Accel working
• [x] Baro working
• [ ] Voltage correct
• [ ] Current correct
• [ ] Analog RSSI
• [x] Mag I2C Bus
• [x] UART1
• [ ] UART2
• [x] UART3
• [ ] UART4
• [x] UART5
• [ ] UART6
• [ ] LEDs working
• [ ] Buzzer working
• [ ] Motor outputs
• [ ] DShot support on m1-4
• [ ] Servo outputs
• [ ] Blackbox
• [x] Analog Camera working
• [x] Video Out working
• [x] OSD working
• [x] PINIO1
• [ ] PINIO2

Motors will spin up on initial arm. bring up throttle and motors will stop except for atleast 1. different each time. motors will not arm without disconnecting battery after that. won't spin up with Dshot150 and only M3 and M4 with DShot600.

Camera appears to switch. need to have it set in modes. VTX power doesn't appear to work.