inav Add new target CORVON743V1

Dear iNav Developers, I am writing to introduce our company Feikong Technology Co., Ltd. We specialize in designing and manufacturing hardware components for drones under our brand name, CORVON. we have tested our flight controller "CORVON743V1" well, hope could add it to iNav supported hardware. Looking forward to contributing to iNav. Best regards Holydust

Apr 30 '25 02:04 holydust

I have the test sample on my bench and will test it.

Apr 30 '25 02:04 sensei-hacker

[x] Samples received
[x] Flash firmware
[x] Calibrate
[x] Orientation matches
[x] Gyro working
[x] Accel working
[x] Baro working
[x] Voltage correct
[x] Current correct
[ ] Analog RSSI - NONE
[x] Mag I2C Bus
[x] UART1
[x] UART2
[x] UART3
[x] UART4
[x] UART6
[x] UART7
[x] UART8
[ ] LEDs working - NONE
[ ] Buzzer working - NONE
[x] Motor outputs
[x] DShot support on m1-4
[x] Servo outputs
[x] Blackbox
[x] Analog Camera working
[x] Video Out working
[x] OSD working
[ ] PINIO1
[ ] PINIO2

Jun 21 '25 00:06 sensei-hacker

DSHOT verified on S1-S9. Servo / pwm only on S10. For the UARTS, only UART1 did not pass.

Confirming @holydust there is no pinio to turn the VTX power off or any other purpose?

Jun 23 '25 00:06 sensei-hacker

DSHOT verified on S1-S9. Servo / pwm only on S10. For the UARTS, only UART1 did not pass.

Confirming @holydust there is no pinio to turn the VTX power off or any other purpose?

Thanks Yes, VTX power is always on, we didn't set pinio to control it.

Jun 30 '25 07:06 holydust