iNavFlight
HDzero Video Feed appearing black when using MSP
Current Behavior
INAV 7.1.1 just flashed on the SPEEDYBEEF405WING with inav 7.1.1 configurator . no previous settings applied. Turn on my googles HDzero and video is fine no OSD or control. MSP display port activate on port 5 , no video showing when powered by battery and not connected to PC. If plugged into PC with MSP active and power with battery then Video works with OSD but no control.
Steps to Reproduce
Tried clean install again with 7.1.1 Video works with no settings applied with MSP port 5 set, get no video with battery plugged in no PC with PC plugged in and then battery connected i get video with OSD but no VTX control
Expected behavior
Expected video output with working OSD and MSP control of VTX and camera
Suggested solution(s)
My plan will be to install 6.1.1 as ive been advised this works.
Additional context
(https://pastebin.com/hLHCL03U)
version
INAV/SPEEDYBEEF405WING 7.1.1 May 6 2024 / 12:49:15 (dd91a871)
GCC-10.3.1 20210824 (release)
- FC Board name and vendor: Speedybeef405wing
- INAV version string:7.1.1
apeears the issue with the black screen was caused by the vtx settings in the config not being correct, the settings need to be set to either raceband or low band depending what your using, the MSP control is still not working and tx vtx button control not working on HDzero version 1.6, but works on 1.5