7 Final release gives issues

[0crap]

~~- Battery profiles do not update when switching~~ ~~- Settings validated checkmark stays red (even when known good diff all is applied)~~

• After full erase and flash it hangs after apply defaults for wing - Still a bug in final release. -

Tested with ~~INAV-Configurator_win64_7.0.0-RC2.zip~~ INAV-Configurator_win64_7.0.0.exe and Matek H743-Wing V2 None of these issues with Configurator 7 RC1.

[RoadyFPV]

same here, it shows on reboot "ez tune" tab is there. after u close configurator and connect again "ez tab" is not there and settings validated is red. cli status show ez_filter_hz error

[RoadyFPV]

same in release version

stuck in: Device - Saving default settings

[0crap]

same in release version

stuck in: Device - Saving default settings

Confirmed here as well. That is just sloppy. No reason not to do a RC3 for the Configurator to see if this was fixed. Now it's still there in the final release. Nice...

(Opening post edited to reflect the current situation.)

[Yury-MonZon]

Same here on linux x64 7.0 version Matek F411WTE

[Scavanger]

It's just a cosmetic error. Just click on the big X right above.

[rickgode]

So just close out after applying default values? It hung on a speedybee f405 mini, but resetting the settings and going through the default values prompted the window to pop up to apply the default values and it worked.

But on a matek f405 mini, that didn't work, so I just clicked on the big X, went into the CLI and applied my diff and hopefully all is well.

[RoadyFPV]

its not a cosmetic error, after u click on x and start configurator again ez tab is missing

[Yury-MonZon]

After initial flash (full erase enabled) and applying the default mixer for delta wing I get the same issue and my settings profile and battery profiles got switched to 2. I was expecting profile 1 and battery profile 1.

[MrD-RC]

its not a cosmetic error, after u click on x and start configurator again ez tab is missing

Are you setting up a multirotor? If not it is working correctly. EzTune is only for multirotors.

[RoadyFPV]

thanks for the clarification. in the rc version, ez tab was also displayed for airplane. i will check it again. and the boot stuck on saving defaults?

[0crap]

.... and the boot stuck on saving defaults?

This is still a bug as mentioned in the opening post.

[MrD-RC]

thanks for the clarification. in the rc version, ez tab was also displayed for airplane. i will check it again. and the boot stuck on saving defaults?

Yes, that was a bug. It was fixed in RC 2 or 3. You should not see the Ez Tune tab if not setting up a multirotor.