rpi-rgb-led-matrix icon indicating copy to clipboard operation
rpi-rgb-led-matrix copied to clipboard

Published 20 hours ago • verified publisher icon hzeller

Maximum Refresh Rate

Open AyoubWalid opened this issue 5 years ago • 4 comments

Hello Zeller,

I am developing an application where it is required to have a very high refresh rate, the application requires a camera to take a photo at a certain instant of the LED matrix display, and a high refresh rate is required to avoid conflicts with the camera shutter speed, and frame rate to avoid a case where a photo is taken in between transitions (or while scanning) This is an example of what I required to avoid. https://www.danielbowen.com/2016/03/03/photographing-led-displays/

I have found LED matrix display with relatively high refresh rates at around 3.8kHz, my question is whether there is a hardware or software limitation to achieve such high rates using this library in combination with a controller such as the Active 3.

AyoubWalid avatar Jan 20 '20 10:01 AyoubWalid

@WalidAyyoub see https://github.com/hzeller/rpi-rgb-led-matrix/pull/971 and https://github.com/hzeller/rpi-rgb-led-matrix/issues/918 The higher the resolution, the less refresh rate you get (also if you have 1/4 panels, i.e. AB panels) instead of ABCD or ABCDE (/16 or /32), the refresh won't look as bad). What panels/resolution are you seeing 3.8Khz on? Seems easy/possible with 64x32 AB panels, but harder with 128x64 panels, where I only seem to get 500Hz best case, which is 8 times slower than what you're seeing when the resolution is only 4 times less, so I'm not sure where the 2x factor went.

marcmerlin avatar Jan 30 '20 19:01 marcmerlin

3.8kHz you typically see on 32x16 panels with 1:4 multiplexing.

hzeller avatar Jan 30 '20 20:01 hzeller

Right, with a panel that small (16 times smaller than the one I tested), the math adds up. @WalidAyyoub basically what this means though is that you're only going to get such a high refresh rate by having a CPU/FPGA drive small panels independently. No chaining, no big panels. That said if you get /4 or /8 panels (AB or ABC), even if you don't get a super high refresh rate, each line will be displayed a longer amount of time, and will be less likely to look flickery when using a camera.

marcmerlin avatar Jan 30 '20 20:01 marcmerlin

You will not be able to get really high refresh like that without S-PWM or quality reduction. Receiver cards can which these are made for can.

greatballoflazers avatar Oct 29 '21 03:10 greatballoflazers