Thomas

yea, tell me about it. I finally got the 21E up and running with 32kB of flash in Arduino land. Fine for 8bit architecture but not for 32bit SAMD21 architecture!!...

Yes! the screw terminals are for adding sensors too. Nothing identified but that's what they are for. I agree load cells are super important for looking at hive health and...

Also, If you are digging into this... I'm missing the jumpers on this CAD version. Do you follow? They are in the gerber files. They jumper the LED resistors. Just...

ha.. good luck. You can also use an old digital camera to see the IR leds.... if you still have one of those.

Sure, if you find it helpful. Thanks On Tue, Mar 24, 2020, 3:46 PM owendelong wrote: > I’ll find something that works… If I do end up building a device...

Hey there, sorry for the delay getting back to you. I lost my access to Eagle Pro ( left my previous job) so I actually transitioned to kiCAD and added...

it wasn't as bad as I thought it would be. What really forced me to try it out was when I needed to make edits to this large board!... There's...

ok, I did a library export using ULP and put the libraries folder in with the eagle files: https://github.com/hydronics2/2019-easy-bee-counter/tree/master/PCB_files/Eagle_v0.2 FYI, I'm pretty sure I got those reflective sensors from the...

wowa... that's really neat. very elegant design. On Sun, May 24, 2020 at 4:38 PM owendelong wrote: > Here's a Fusion 360 animation of what I have in mind for...

From my experience they actually don't propolize over the sensors... they do propolize around the sides of the sensors, around the leads, on any voids or holes. On Tue, Dec...