huskeyw

It's how the board is wired from hobbytronics.. I did it both ways.. intresting that no matter where I put serial the propeller will let it be reprogramed, On Fri,...

Well, I need to grab the oscope and logic probe.. I added some debug and it does not print that either.. so something on the board is causing it to...

I am sure it's this board, or something I screwed up. Have not had time to get back to it, thanks for the support On Mon, Mar 25, 2019, 01:19...

I only see two capacitors on the board.. I took a logic probe and with their code I get lots of activity on the vga pins, but with yours its...

as an added note, I just built your code, no changes, just unzip build and load, and it does not boot the chip.. does propeller have a debugger IDE? Really...

[email protected] On Wed, Mar 27, 2019, 11:22 Marko Lukat wrote: > .. but like I said, Ill send you this board if you want to hack on it.. no >...

so once you grounded it that pin it worked? On Thu, May 9, 2019, 11:52 Marko Lukat wrote: > Progress so far (programming done with PropPlug): > > - I...

I used a propeller prop and the command line tool, not sure how I could get that wrong.. but maybe I had something wrong.. my finial goal was to get...

Just my two cents.. A USB device that could connect to the drive and maybe just share data to the PI (even if it cashed it and presented like a...