UART connection using NanoVNA-H v3.4 with UARt pins (VDD, TX, RX, GND) available on PCB.

[AdvaithSiva]

Hi Hugen, I am not sure if this is the best place to raise this issue. What would be the best and easiest way to access NanoVNA data via UART? Does the latest firmware accommodate UART connection? Is there a guide to the commands and other resources for UART communication? Any help in this matter would be highly appreciated, Hugen

Thank you

Kind regards Advaith

[DiSlord]

UART connection avaible and use equal commands as on over USB->COM connection

But need change commands source in CONFIG->CONNECTION menu (and also select speed) If need save settings - use CONFIG->SAVE CONFIG