home-assistant
Fresh install restore backup silently fails due to wrong supervisor version
Checklist
- [X] I have updated to the latest available Home Assistant version.
- [X] I have cleared the cache of my browser.
- [X] I have tried a different browser to see if it is related to my browser.
- [ ] I have tried reproducing the issue in safe mode to rule out problems with unsupported custom resources.
Describe the issue you are experiencing
Setup a fresh install of Home Assistant on a Raspberry Pi 4 and attempted to restore my backup.
The backup was taken on a version with the very latest update to supervisor which the Pi didn't have.
The first run setup accepted the backup file and said it was restoring but after several hours I cancelled and nothing had happened.
Later, I did a fresh HA Install and a new setup. Once I was in I then tried to restore from that environment.
At that point the UI told me the backup was made with a newer supervisor than what was installed.
Describe the behavior you expected
The first run setup should have indicated that the backup was created with a newer version of supervisor and couldn't be used.
Steps to reproduce the issue
- Create backup with newer HA supervisor version
- Setup a clean install
- Attempt to recover the backup to the new install
What version of Home Assistant Core has the issue?
2024.6.4
What was the last working version of Home Assistant Core?
No response
In which browser are you experiencing the issue with?
No response
Which operating system are you using to run this browser?
No response
State of relevant entities
No response
Problem-relevant frontend configuration
No response
Javascript errors shown in your browser console/inspector
No response
Additional information
No response
