node-red-contrib-zigbee

node-red-contrib-zigbee copied to clipboard

Lost connection to controller after upgrade

3

Just updated the node to 0.20.3 and, after restarting Node-Red service (stand alone linux, no docker) there is no "connected" indicator on controller, event or any other zigbee nodes. Everything...

adi-dev

Hallo, ich habe folgende Konfiguration: Raspberry Pi 4, 4GB Homematic IP RF module via USB Conbee 2 USB-Stick mit Verlängerung und Firmware deCONZ_ConBeeII_0x266b0700.bin.GCF Raspberrymatic Version 3.57.5.20210424 Cux Daemon 2.6 RedMatic...

tuxmatic

GL-C-008: how to control RGB, WW and CW independently?

5

The GL-C-008 offers 5 outputs (RGB, WW and CW) but I am not able to set a RGB value while a WW/CW value is active without switching WW/CW off. Is...

baycom

Device Pings führen zu Crash des Zigbee Sticks

1

Converter beinhaltet 9 Geräte. Unter Device Config -> Checkbox Ping für alle Geräte (9 Stk., allesamt Lampen) aktiviert. Viele Pings belasten den Stick und führen dazu, dass nach einem Build...

ghost

Hello, the only reason I use ioBroker is to control my xiaomi zigbee devices (CC2531 usb stick). As i saw this node i decided to remove the ioBroker from my...

Cartman18

Node-Red in Docker. After restarting all paired devices are gone.

15

First of all, thank you for your great work. I'm using Node-Red in Docker in archlinuxarm. After restarting the docker image using the "docker restart node-red" command all paired devices...

ckhmer1

Allow Zigbee Converter to get/set state of groups

2

As described in "https://www.zigbee2mqtt.io/information/groups.html" Controlling a group is similar to controlling a single device. For example to turn on all devices that are part of group send a MQTT message...

Hypnos3

Danalock not answering commands and not sending status information

3

Hello together, today I installed my new Danalock V3. The connection with the controller was no problem, i can also send commands and the device ist opening and closing. My...

fbeek

I am currently evaluating different home automation and Zigbee solutions. I am using a TI CC2531 USB and the following ZigBee devices: - Osram Smart+ switch mini - https://www.zigbee2mqtt.io/devices/AC0251100NJ_AC0251700NJ.html -...

Vermatic

Raspberrymatic Redmatic CC2652RB speichert angelernte Devices nicht

3

Hallo Betreibe in Raspberrymatic mit Redmatic und dem Zigbee Plugin, aus dem Paketzentrum von redmatic, einen CC2652RB. Dieser ist mit dev/ttyUSB0 und rtscts auf false konfigurieret. Beim anlerne findet er...

miktin