Printer Crashes when Running Bilinear Leveling after Running X-Twist Compensation

[WilliamShiner]

After running through X-twist compensation, I store settings and immediately go to re-run ABL. This causes every single motor (including the extruder) to run at maximum speed, ramming the nozzle into the bed and dragging it. Any ideas?

[wongcoder]

Wow. This sounds like the inductive sensor and bumpstops arent working. I never had this experience with this firmware, but I do know development for this firmware has since been deprecated. I use manual mesh and I find it doesnt tend to vary