hiddify
WARP & sysctl errors
Here's what my service status looks like:
- Services Status:
hiddify-cli active
hiddify-redis active
hiddify-ssh-liberty-bridge active
hiddify-haproxy active
hiddify-panel active
hiddify-nginx active
hiddify-singbox active
hiddify-xray active
wg-quick@warp failed
mtproto-proxy active
As you can see, it shows wg-quick@warp as failed.
Further inspection reveals this:
Jul 10 22:36:06 hiddify-sg systemd[1]: Starting WireGuard via wg-quick(8) for WARP...
░░ Subject: A start job for unit [email protected] has begun execution
░░ Defined-By: systemd
░░ Support: http://www.ubuntu.com/support
░░
░░ A start job for unit [email protected] has begun execution.
░░
░░ The job identifier is 97590.
Jul 10 22:36:06 hiddify-sg wg-quick[107206]: wg-quick: `/etc/wireguard/WARP.conf' does not exist
Jul 10 22:36:06 hiddify-sg systemd[1]: [email protected]: Main process exited, code=exited, status=1/FAILURE
░░ Subject: Unit process exited
░░ Defined-By: systemd
░░ Support: http://www.ubuntu.com/support
░░
░░ An ExecStart= process belonging to unit [email protected] has exited.
░░
░░ The process' exit code is 'exited' and its exit status is 1.
Jul 10 22:36:06 hiddify-sg systemd[1]: [email protected]: Failed with result 'exit-code'.
░░ Subject: Unit failed
░░ Defined-By: systemd
░░ Support: http://www.ubuntu.com/support
░░
░░ The unit [email protected] has entered the 'failed' state with result 'exit-code'.
Jul 10 22:36:06 hiddify-sg systemd[1]: Failed to start WireGuard via wg-quick(8) for WARP.
░░ Subject: A start job for unit [email protected] has failed
░░ Defined-By: systemd
░░ Support: http://www.ubuntu.com/support
░░
░░ A start job for unit [email protected] has finished with a failure.
░░
░░ The job identifier is 97590 and the job result is failed.
On another note, I also get these errors;
sysctl: setting key "net.ipv4.conf.all.accept_source_route": Invalid argument
sysctl: setting key "net.ipv4.conf.all.promote_secondaries": Invalid argument
I have tried reinstalling to no avail.
same here:
85####Installing...####Wireguard####
===install.sh other/wireguard sysctl: setting key "net.ipv4.conf.all.accept_source_route": Invalid argument sysctl: setting key "net.ipv4.conf.all.promote_secondaries": Invalid argument ===run.sh other/wireguard
I made a backup, and did a restore keeping only user information. The rest I reconfigured from scratch and it has been fine.
I was still unable to address the sysctl errors.
1.Make a backup 2. rebuild server to ubuntu 22.04 3. install latest version of the panel 4.restore backup you can follow all learning's material about the panel here: hiddify.com/manager hiddify.com/fa/manager
