esphome_components

esphome_components copied to clipboard

V2 - Channel 9 and 10 is showing temperature at 0 degrees celcius

7

I just set up the V2 of the wavin component. It all works splendid, except for channel 9 and 10, which always shows the current temperature at 0 degrees celcius....

mathias-jakobsen

Hardware requirements

6

Hello. I am new in the field of esp32. Can any of you share what hardware you use to run this project. I already have an Optima 250 installed.

MathiasReker

heinekmadsen

Added ID to all climate entities. This enables using !extend and !remove of these entities, which does require an ID (https://esphome.io/guides/configuration-types.html#extend) Added visual settings to each channel. Setting set temperature...

Jopand

Update wavinahc9000v2_climate.cpp

1

Setting temperature step individually for target (0.5) and current (0.1) so the steps in home assistant GUI matches the steps in the Wavin system.

HenrikHagen

pin connections? :)

5

Am i missing something or dont this repo have info about how to connect the board to the genvex? :) I have been looking into the following: Optima 250 and...

McAndersDK

Kitchen uses 2 channels, but only has a wall sensor on 1

26

Our kitchen use both channel 5 and 6 for the floor heating, but only channe 5 has a wall mounted controller/sensor. This means that when using the Wavin components, all...

dkgof

Wavin doesn't seem compatible with ESPHome 2022.7

2

Just updated to dev channel on my ESPHome, and it seems like the Wavin component is not compatible. 

MTrab