heinekmadsen

I found a 10k ohm, but still no cigar 🤥  Should I try some higher ohm resistor?

Still no blue flashing, only red flashes and red status in the ui

So i tried checking the led... I can't measure any short circuit.... I tried taking some pictures and a video when it's in the meter   https://user-images.githubusercontent.com/48906528/137384870-450b283f-cbae-4466-995e-a8fc9d39fc8d.MOV Just thinking...

@gskjold not sure how to tie this with #73... But... i do recall that i might have read somewhere on the internet, that smart-me works by pull and amstomqttbridge works...

Well.. that might be a dead-end :( https://www.ihc-user.dk/forum/forums/topic/7467-kamstrup-elm%C3%A5lere/?do=findComment&comment=58737 A KMP protocol... Will try to reach out to Kamstrup and see if they are willing to hand out some documentation for...

Maybe this could be flagged as a warning and the if fails after the retry then an error?

This also have my interest On the z2m devices page for Heimgard lock is need a "expose_pin" setting. https://www.zigbee2mqtt.io/devices/HT-SLM-2.html

@jkaberg nice find... hope some one with knowledge has time to get the last bits and pieces together so we have the full support. I have been in contact with...

@Koenkk Can you give us a hint in any direction on how we can continue to improve this?

The data is there for sure (hope so)... Had a chat with EasyAccess/Nimly support who stated that the Nimly gateway get that information from Zigbee. I think the issue is...