terraform-aws-vpc
terraform-aws-vpc copied to clipboard
A Terraform project to spin up an Amazon Web Services Virtual Private Cloud.
terraform-aws-vpc
This goal of this project is to easily spin up an Amazon Web Services (AWS) Virtual Private Cloud (VPC) using Terraform.
Configuration
The project root contains a file named terraform.tfvars.example
. Rename that file to terraform.tfvars
and populate it with your AWS credentials:
$ mv terraform.tfvars.example terraform.tfvars
$ vim terraform.tfvars
There is also a variables.tf
at the project root. It contains a listing of all the Terraform variables. Some defaults are set there as well. If you want to override any of them, override them in terraform.tfvars
.
Usage
All of the interactions with Terraform are wrapped in a Makefile
. It contains targets for planning, applying, and destroying changes to your AWS infrastructure.
Plan
The plan phase takes your Terraform configuration and attempts to provide you with a plan of what it would do if you applied it. It outputs an execution plan to stdout
along a terraform.tfplan
file (not human-readable).
$ make plan
Refreshing Terraform state prior to plan...
The Terraform execution plan has been generated and is shown below.
Resources are shown in alphabetical order for quick scanning. Green resources
will be created (or destroyed and then created if an existing resource
exists), yellow resources are being changed in-place, and red resources
will be destroyed.
Your plan was also saved to the path below. Call the "apply" subcommand
with this plan file and Terraform will exactly execute this execution
plan.
Path: terraform.tfplan
Apply
The apply phase simply takes the Terraform execution plan and attempts to execute it. It outputs its progress to stdout
along a terraform.tfstate
file (not human-readable).
$ make apply
aws_vpc.default: Creating...
cidr_block: "" => "10.0.0.0/16"
aws_vpc.default: Creation complete
Apply complete! Resources: 1 added, 0 changed, 0 destroyed.
The state of your infrastructure has been saved to the path
below. This state is required to modify and destroy your
infrastructure, so keep it safe. To inspect the complete state
use the `terraform show` command.
State path: terraform.tfstate
Destroy
The destroy phase happens in two steps. First, Terraform generates a destroy execution plan, and then applies it. It outputs an execution plan to stdout
along a new terraform.tfplan
file. After that, it attempts to apply the destroy execution plan.
$ make destroy
Refreshing Terraform state prior to plan...
aws_vpc.default: Refreshing state... (ID: vpc-20bf1d45)
The Terraform execution plan has been generated and is shown below.
Resources are shown in alphabetical order for quick scanning. Green resources
will be created (or destroyed and then created if an existing resource
exists), yellow resources are being changed in-place, and red resources
will be destroyed.
Your plan was also saved to the path below. Call the "apply" subcommand
with this plan file and Terraform will exactly execute this execution
plan.
Path: terraform.tfplan
- aws_vpc.default
aws_vpc.default: Destroying...
aws_vpc.default: Destruction complete
Apply complete! Resources: 0 added, 0 changed, 1 destroyed.
Note: The destroy
step usually has to be run more than once because of an issue with deleting the Elastic IP (EIP) before it is unbound from the NAT instance. Run make destroy
again after the failure to complete the destroy phase.