Andrea Gulberti

@stickbreaker Hi, actually I tried them both. I ended up in this branch since I read something about the fact that the main repo provides a poor implementation of the...

@stickbreaker thank you, but now even if I run a simple i2c scanner, the result are 20 lines of _Bus Invalid State, can't init sda=1, scl=0 _ can I recover...

@stickbreaker no I don't! Now I put 3k, is it ok? Should I disable the internal ones of esp32? The sensor has internal pullups of 2.2k also. In any case,...

Ok I'll take an UNO. It will take a day or two. What about the pull-ups I told you? And the low-pass filter? Since I changed 3 sensors, and I...

Tried with UNO. Ran this basic sketch https://playground.arduino.cc/Main/I2cScanner After the first loop, it blocks.  I have in total 5 accelerometers, 3 of them are in this state. I can...

No, without voltage converter! But actually I have always used this sensor with Arduino at 5V, and it has always worked! Also I tried with the two remaining sensors I...