upgrade-run.sh gets stuck at Rebooting to UPGRADE MODE

[Scags104]

The upgrade script has now taken down 2 of my cameras and put them in some odd boot loop im not sure know how to fix

SD_ROOT/wz_mini/lib/libcallback_t20.so: OK SD_ROOT/wz_mini/lib/libasound.so.2: OK SD_ROOT/wz_mini/lib/libaudioProcess.so: OK SD_ROOT/wz_mini/wz_mini.conf: OK SD_ROOT/wz_mini/tmp/.gitignore: OK v2_install/compile_image.sh: OK v2_install/fw_tool.sh: OK v2_install/v2_kernel.bin: OK v2_install/.gitignore: OK File verification successful! Move staging directory to perform upgrade Installing latest upgrade-run from repo Launching latest upgrade-script Exit old script Resume upgrade-run, latest version check for old directory path [root@Wyze_Driveway_Camera:etc]# enable wifi drivers if disabled in config Backup user config Rebooting into UPGRADE MODE

...stays here for a few minutes and then: client_loop: send disconnect: Connection reset

They havent reconnected back to my network since this happened after a few power cycles either. Do i need to reimage the whole SD card?

[archandanime]

I believe so, I encountered this issue multiple times and it seems that formatting SD card is the only reliable solution.

[KillahB33]

My cameras came back up but even after setting up the go2rtc it was giving me black screen on the stream so will have to go with a fresh install.

[aejeffor]

Same behavior here. Upgrade a handful of camera from oct ‘22 release and they error out because go2rtc.yaml doesn’t exist in that older version. I tested in a newer wzmini version that did have that particular file (July ‘23). Similar behavior, although there is no error. It simply states “rebooting into upgrade mode” and then bricks the camera.