gromgsxr

i edited the sonoff section to match the correct pid and vid for the binnatron stick after that it was able to read the firmware version on the stick and...

there is a link in my first post ta a thread where i found the file. its NCP_USW_EM3587-LR_678-115k2.ebl

stock was 5.8.0.0 and upgraded to 6.7.8-373

vendor id 4292 is 10C4 in hex and 35636 is 8B34 in hex so same pid and vid. i attempted to make a pull request adding support for the stick

The only thing that may cause problems if you update is the new baud rate as stock it 57600 and the firmware I used was 115200 I don't use openhab...

the version you mentioned flashes to my stick ok i didn't test if it actually works though, and i was able to flash it back the the one i had...

Don't use openhab I submitted a pull requests to add support for this device on this repo

Is there any update on this?

is support likely to get added for this?

> Someday, probably. But, as covered above, CANTact support works fine through the socketcan interface on Linux so using WSL could work. It's certainly not ideal. I really should implement...