STM32F4xx issues

Octopus Pro F429 - will it work?

10

Hi guys! very new to the grblHAL world, and all the CNC world for that matter. Building a Mill machine currently and I would like to use an octopus board...

nameisCruzCruz

we agree stm32 doesn't work with tmc2130 in spi

1

it's currently in experimental mode?

maximeh2

Can you implement the kinematics for the scara arms?

17

obsolete, useless? thanks in advance

maximeh2

nucleo 64 f401 re with cnc breakout trinamic missing CS X Y Z pin

1

Although in the webbuilder the trinamic drivers are available in the pinout of this board there are the spi pins but CSX CSY CSZ is missing and for tmc2209 no...

maximeh2

Ethernet only connect when usb is connected and used by sender

11

Hi, i using a board stm32f407vet6 and compiled version of the grblhal activating ethernet, that works correctly when connect first the usb cable and iosender for check boot. But when...

semos2k

BTT SKR2.0 Spindle Sync and HSM PostPro for Lathe

3

Hello, I just get a BTT SKR2, is there a reason that spindle sync is not available on this board? (tried in webbuilder) 2nd The target is a lathe, what...

JoachimF

grbl for Nucleo-F401RE.

1

I am using nucelo-f401re, want to install grbl firmware in it. how can I modify these resources to do so.

PaONEkaruchola

Loss of position

26

good morning terjeio.... I have a problem with the code, I realized that it is losing steps in a large gcode, I did several tests with servomotors which give higher...

Juank23