github051

>  >  > Well, with grief, I started the board. I checked everything works, it remains only to start the USB - FLASH CARD, this function is not...

> Hello, the original version is no longer there, because I tried to integrate work with a USB flash drive into the system and, as a result, abandoned this business...

For me also same issue with USB printing. SD card work ok. But while printing circles it makes click noise. Dont know what is the issue. I think Makerbase is...

> Do NOT use their software as you see there is no support nothing. Also their software closed which 3d printer community doesnt like. > > Just install 32bit Marlin...

> If you are using Robin firmware, this parameter cannot change. We will consider the new firmware can change it in the future. When can we expect the New version...

I think from last 6 moths there is no version upgrade. Please concentrate on MKS Robin and improve the firmware.

You cannot use both. Use only one

Change the power loss recovery low to high or viceversa.

Finaly, I did it today. Bltouch is working with Mks Robin V1.4.

> bootloder for stm32f103 series, maybe stm32f103zet6 is mks-robin boards,i just cautious or confirm if the bootloder is special and must exit flash at the start program.i think all stm32f103...